Updates

оn the page:

11

oсtober

2017

Kristall, Arbat, Decor, Comet, ComeIn

Interaction curves can now be scaled and shifted with the mouse.

6

oсtober

2017

SCAD++

You can now control the groups of unification of steel elements.

2

oсtober

2017

Arbat, SCAD++

The Reinforcement information mode now enables to determine the reduced diameter, the equivalent diameter and the center of gravity of the reinforcement.

3

april

2017

WeST

Support for SP 20.13330.2016 has been added; except for the Location and Wind modes (they are in development).

3

april

2017

Arbat

The unnecessary calculation of a factor according to Sec.8.1.16 of SP 63.13330.2012 was performed in the Strength of Sections mode. This error has been corrected.

31

march

2017

SCAD++

Corrosion can now be taken into account when checking steel structural members.

27

march

2017

SCAD++

Support for SP 20.13330.2016 has been added.

24

march

2017

COMET

A new factor describing the load-bearing capacity of the structural members (e.g., beams, columns, truss members) connected in the designed joint has been added to all the design modes of the software.

A new tab, Interaction Curves, has appeared in all the design modes of the software. It enables to plot a family of graphs bounding the load-bearing capacity area of the joint depending on the selected pair of internal forces acting in the designed joint.

A new factor “Resistance of the base plate under bending caused by tensile forces in the anchor bolts” has appeared in the Nominally Pinned Column Bases mode.

The Nominally Pinned Column Bases mode enables to check the shear force transfer through friction at the contact between the base plate and the foundation concrete.

The checks of joints according to EN1993-1-1, EN1993-1-5 and EN1993-1-8 have been refined.

Loads transferred to the wing plates analyzed as cantilever beams have been refined in the Rigid Column Bases mode.

23

march

2017

WeST

The Location mode can now be used to display maps (for the RF) with the help of Google Maps.

23

march

2017

Assortments according to TU 1381-103-05757848-2013, TU 0925-016-00186269-2016, TU 0925-036-00186269-2016 have been added.