SCAD++

Support for SP 20.13330.2016 has been added.

COMET

A new factor describing the load-bearing capacity of the structural members (e.g., beams, columns, truss members) connected in the designed joint has been added to all the design modes of the software.

A new tab, Interaction Curves, has appeared in all the design modes of the software. It enables to plot a family of graphs bounding the load-bearing capacity area of the joint depending on the selected pair of internal forces acting in the designed joint.

A new factor “Resistance of the base plate under bending caused by tensile forces in the anchor bolts” has appeared in the Nominally Pinned Column Bases mode.

The Nominally Pinned Column Bases mode enables to check the shear force transfer through friction at the contact between the base plate and the foundation concrete.

The checks of joints according to EN1993-1-1, EN1993-1-5 and EN1993-1-8 have been refined.

Loads transferred to the wing plates analyzed as cantilever beams have been refined in the Rigid Column Bases mode.

WeST

The Location mode can now be used to display maps (for the RF) with the help of Google Maps.

Assortments according to TU 1381-103-05757848-2013, TU 0925-016-00186269-2016, TU 0925-036-00186269-2016 have been added.

Assortments of circular, square and rectangular hollow sections according to EN10219-2:2006 (E) have been added.

Decor

When calculating Arches, the steel for the tie can be selected.

New assortments according to TU 0925-001-97638531-2016, TU 1120-001-82861223-2009 have been added.

SCAD++

A model (or its fragment) can now be copied along a trajectory.

SCAD++, Arbat

Modification No.2 of SP 63.13330.2012 has been taken into account in the selection and check of transverse reinforcement

SCAD++

Add-in have been added for the data exchange with ArchiCAD 19 and ArchiCAD 20.

SCAD++

The color scale of the unsupported lengths of bar elements has been added.